NEC MultiSync E658 - Page 57

English - 54
Network Settings
Click on “NETWORK” on the left-hand column on the HOME screen to enter the setting screen.
Top
INPUT SOURCE: HDMI1
STATUS
PROTOCOL
NETWORK SETTINGS
DHCP
INTERFACE
IP ADDRESS 192.168.0.10
Off
SUBNET MASK 255.255.255.0
DEFAULT GATEWAY 0.0.0.0
DNS PRIMARY 0.0.0.0
DNS SECONDARY 0.0.0.0
NETWORK
SYSTEM
LOGOUT
TCP
ROOMVIEW
CRESTRON CONTROL
AMX
NAME
DHCP Select a method for setting the IP ADDRESS.
Off: Setsxednetworksettings.
On: Obtains the network settings from the DHCP server on the network.
Manual DNS: Obtains the network settings from the DHCP server on the network but the DNS
is set manually.
NOTE Consult your network administrator if you have any trouble with the connection.
IP ADDRESS Set the IP address for the monitor connected to the network when [Off] is selected for [DHCP].
SUBNET MASK Set the subnet mask for the network to which the monitor is connected when [Off] is selected for
[DHCP].
DEFAULT GATEWAY Set the default gateway for the network to which the monitor is connected when [Off] is selected for
[DHCP].
Enter [0.0.0.0] to delete the setting.
DNS PRIMARY Enter the IP address of the primary DNS server of the network connected to the monitor.
NOTE Enter [0.0.0.0] to delete the setting.
DNS SECONDARY Enter the IP address of the secondary DNS server of the network connected to the monitor.
NOTE Enter [0.0.0.0] to delete the setting.
ROOMVIEW Settings
Click on “ROOMVIEW” on the left column below HOME.
ThemonitorsupportsCrestron’sROOMVIEW,allowingmultipledevicesconnectedinthenetworktobemanagedandcontrolled
from a computer or a controller.
ROOMVIEW Enables or Disables managing from the computer.
PORT Sets the Crestron port used for Ethernet communication.
For further information, visit http://www.crestron.com