1
1. Preparing User Supportware 3
17
Preparing User Supportware 3
● Installing PC Control Utility 3.0
1
Click [Installing PC Control Utility 3.0] in the menu screen.
Preparation for the installation will begin.
When preparation is complete, "Welcome to the InstallShield Wizard for PC Control Utility 3.0" screen
is displayed.
• After that, follow the instructions on the screen to continue the installation.
• When installation is complete, the menu screen of the User Supportware 3 CD-ROM is displayed
again.
● Completing installation
1
Click [Exit] on the menu screen.
The menu screen will close.
2
Remove the User Supportware 3 CD-ROM from the CD-ROM drive.
■ Uninstalling
The following procedure removes the installed software from the hard disk.
Uninstall one software program at a time.
1
Click [Control Panel] in the start menu → [Add or Remove Programs].
A list of programs currently installed will be displayed.
2
From the list of installed software, select the software to uninstall.
3
Click [Remove] on the right of the screen.
A confirmation message will be displayed.
• To uninstall Ulead Photo Explorer 8.0, click [Change/Remove], [Remove], and [Next].
4
Confirm the software program name to be removed and click [Yes].
Uninstallation of the program will begin.
5
After an installation of the program is complete, a message prompting you
to restart the system may be displayed. In this case, click [Yes].
Note
• When installing Viewer PPT Converter 3.0 onto a personal computer that has PowerPoint
installed, Viewer PPT Converter 3.0 is automatically registered as a Power-Point add-in.
It is necessary to cancel Viewer PPT Converter 3.0 add-in before uninstalling Viewer PPT
Converter 3.0.
Please refer to Viewer PPT Converter 3.0 Help to unregister the add-in.
To Next Page
Loading...
