1. Preparing User Supportware 3
12
1-3. Installing User Supportware 3
Note
• The following description applies to Windows XP.
• When installing/uninstalling the software in Windows XP, you must log on as a user with
"Computer Administrator" privileges.
For Windows 2000, log on as a user with "Administrators" privileges.
• To install the software in a PC with User Supportware 2 already installed, refer to "7.1
Installation when User Supportware 2 has been Introduced" ( page 48).
■ Installation
● Before starting installation
Preparation:
• Turn on your personal computer and start Windows.
• Before starting the installation, exit all running applications. The installation may not
complete properly if other applications are running.
1
Insert the User Supportware 3 CD-ROM into the CD-ROM drive.
The following menu screen will be displayed.
Reference
If the above menu is not displayed, follow these steps.
1. Click [Start] of Windows.
2. Click [Run...].
3. In the [Open:] field, enter the CD-ROM drive name*1 (e.g., "Q:\") followed by
"SETUP.EXE" (e.g., "Q:\SETUP.EXE).
*1 The CD-ROM drive name will vary depending on your personal computer's
configuration.
4. Click [OK].
The menu will be displayed.
To Next Page
Loading...
