NEC NEAX 2000 IPS - Page 356

Chapter 16 Wireless System
Page 16-18 NEAX2000 IPS Request for Proposal (RFP) Reference Guide
NDA-24349, Issue 4
WCS Required Equipment (Cont.)
EQUIPMENT DESCRIPTION QTY REMARKS
• 10BASE-T Cable
(TIA/EIA category
3 or larger)*
• 100BASE-TX
Cable (TIA/EIA
category 5)*
10BASE-T/100BASE-TX Cable
between ETHER card and Ethernet
Cable Length:
Maximum 100 m (328 ft.)
As required
Router* As required
PN-AP00-B (DBM) Roaming Data Base Module card 1
For Q931a Roaming
over IP Trunk
(Virtual IPT)
PN-IPTB (IPT) IP Trunk card 1-8
PN-4VCTI (4VCT) 4-channel CODEC card 1-32
IPTRK BUS CA Set of 3 BUS Cables between IPT and
4VCT cards
Length: 0.1 m (0.33 ft.)
1-32 sets
• 10BASE-T Cable
(TIA/EIA category
3 or larger)*
• 100BASE-TX
Cable (TIA/EIA
category 5)*
10BASE-T/100BASE-TX Cable
between IPT card and Ethernet
Cable Length:
Maximum 100 m (328 ft.)
As required
Router* As required
PN-AP00-B (DBM) Roaming Data Base Module card 1
For Q931a Roaming
over IP Trunk
(Physical IPT)
PZ-M606-A (ETHER) Ethernet Control Card 1
• 10BASE-T Cable
(TIA/EIA category
3 or larger)*
• 100BASE-TX
Cable (TIA/EIA
category 5)*
10BASE-T/100BASE-TX Cable
between ETHER card and Ethernet
Cable length:
Maximum 100 m (328 ft.)
1
For Short Message
Notification (OAI)