EasyManua.ls Logo

NEC NEAX 2000 IPS - IP Remote Network Capacity

NEC NEAX 2000 IPS
421 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 1 Introduction
Page 1-26 NEAX2000 IPS Request for Proposal (RFP) Reference Guide
ND-24349, Issue 4
IP Remote Network Capacity
Total System Capacity (Main plus Remote)
Item Capacity
LT Ports 1020
AP Ports 256
Analog Single Line Tel. + D
term
980
IP PAD (No. of Channel) 256
D
term
IP/D
term
IP INASET (PTP Connection) 952
D
term
PS 512
Cell Station (CS) / Zone Transceiver (ZT)
128
ISDN Station
128
Central Office Trunk (Lines) 256
Tie Line Trunk (Lines) 2W/4W E&M 192
CCIS Trunk (Peer to Peer Connection) 127
DTI/CCIS Digital Link 1.5M/2M DTI: 10/CCIS: 8 Links
1.5M/2M (PRT) 8
2BRT (card) 24
ISDN
4BRT (card) 24
IP Trunk 8
PFT Connections 64
3-Party Conference Max. 16 conference groups
6-Party Max. 4 conference groups
6-/10-Party Conference
10-Party Max. 2 conference groups
32-Party Conference Max. 8 conference groups
Built-in Router 1 per Site
DTMF Sender/Receiver Max. 32 circuits
Attendant Consoles 8
Attendant Terminal (D
term
ATT Position) Max. 8 sets
SMDR Interface Max. 1 interface port
PMS Interface Max. 1 interface port
ACD / MIS or OAI Interface Max. 1 interface port
Remote PIM over IP Up to 15 (depending on network)
DID Dial Conversion 1000
Call Forwarding-Outside Set 496
Authorization Code / Forced Account Code / Remote
Access to System(DISA)Code
3000
Message Reminder Set 1024
Name Display / Guest Name Display 512
Speed Calling-Station (Station Speed Dial) Set 10000
MP built-in SMDR Call Record 1280

Table of Contents

Other manuals for NEC NEAX 2000 IPS

Related product manuals