Chapter 1 Introduction
NEAX2000 IPS Request For Proposal (RFP) Reference Guide Page 1-25
NDA-24349, Issue 4
IPS
DM
System Capacity (Cont.)
Capacity Per MC
Number of PHYSICAL MODULAR CHASSIS
1 2 3
Built-in Router Max. 5 cards per MODULAR CHASSIS
DTMF Sender Max. 32 circuits per system
DTMF Receiver 16 32
SN716 Desk Console 8
Attendant Terminal (D
term
ATT Position) Max. 8 per system
SMDR Interface Max. 1 Interface port per system
PMS Interface Max. 1 Interface port per system
ACD / MIS or OAI Interface Max. 1 Interface port per system
DID Dial Conversion 1000
Call Forwarding-Outside Set 496
Authorization Code / Forced Account Code / Remote
Access to System(DISA) Code
3000
Message Reminder Set 1024
Name Display / Guest Name Display 512
Speed Calling-Station (Station Speed Dial) Set 10000
MP built-in SMDR Call Record 1280
Note 1: Each Modular Chassis has 24 Virtual LT Ports that can only be used to expand the PAD channels from 8 to
32 using the 8IPLA w/24IPLA.
Note 2: When 8LC card is used, the 4LC w/RGU is required which does not provide Message Waiting indicator.
Note 3: The total number of trunk line and DTI channel shall be 256 or less.
(Each trunk line and DTI channel are required to assign the “Trunk Number” by system data
programming and maximum number of system parameter for “Trunk Number” is 256.)
To Next Page
Loading...
