Chapter 4 Equipment List
Page 4- 4 NEAX2000 IPS
Request For Proposal (RFP) Reference Guide
NDA-24349 Issue 4
Common Control Cards (Cont.)
PN-CP31 MP
Main Processor Card for Remote PIM (DMR)
Provides LAN control function, System-based Device Registration Server
(DRS), built-in FP, 33 MHz PCI BUS, Memory (SDRAM 32 MB, Flash ROM 9
MB), TDSW (1024CH × 1024CH), 16-line CFT, PB sender, Clock, 2-line PLO
(receiver mode/source mode), one RS-232C port, 4-line PB receiver, internal
Music-on-Hold tone, BUS interface.
BUS interface functions as a driver/receiver of various signals, adjusts gate
delay timing, cable delay timing, monitors I/O Bus and PCM BUS.
One card is required per system.
PN-CP15 FP
Firmware Processor Card for NEAX 2000 IPS.
Provides Line/Trunk interface, Memory (RAM 768 KB), and inter-module BUS
interface. BUS interface functions as a driver/receiver of various signals,
adjusts gate delay timing, cable delay timing, monitors I/O Bus and PCM
BUS. When the system consists of three PIMs or more, one each of this card
is mounted respectively in PIM2, PIM4, and PIM6.
3/4 PIM System: 1 per System
5/6 PIM System: 2 per System
7/8 PIM System: 3 per System
PN-CP19 FP
Firmware Processor Card for IPS
DM
Provides Line/Trunk interface, Memory (RAM 768 KB), and inter-module BUS
interface. BUS interface functions as a driver/receiver of various signals,
adjusts gate delay timing, cable delay timing, monitors I/O Bus and PCM
BUS. This card is used for the expansion MC of NEAX IPSDM. When the
system consists of three MC, this card is mounted in MC2.
PZ-M606 ETHER
Ethernet Card, 1 per MP
For Peer to Peer Connection and MAT/OAI
Mounted on MP card to accommodate the Ethernet and transmit/receive a
signal of TCP/IP protocol. Provides Auto Negotiation function (Always set to
ON). 10 BASE-T/100 BASE-TX twisted pair cable is connected directly to
this card.
PN-PW00 EXTPWR
Power Supply Card for DESKCON
Provides –48 V DC power.
Maximum 4 cards per frame (4PIMs). Maximum 3 cards per PIM.
Occupies two physical slots width per card.
PZ-PW121
AC/DC
PWR
Main Power Supply Card
Input: AC120 V/240 V (50 Hz/60 Hz)
Output: –27 V (4.4 A), +5 V (7.2 A), CR (38 mA), +90 V (80 mA)
One card is pre-installed per PIM.
PZ-PW122
DC/DC
PWR
Power Supply Card for Cell Station (Zone Transceiver)
Input: –24 V DC
Output: –48 V DC (1.7 A)
One card per PIM.
Maximum 16 CS (ZT)s backed up by one card.
To Next Page
Loading...
