NEC NEAX 2000 IPS - Page 84

Chapter 4 Equipment List
Page 4- 8 NEAX2000 IPS Request For Proposal (RFP) Reference Guide
NDA-24349 Issue 4
Line/Trunk (LT) Cards
The following table shows a summary of the Line/Trunk (LT) cards for NEAX 2000 IPS. The LT cards
may be installed in slot 00 to 11 of PIM 0-7, with the following conditions:
Line/Trunk (LT) Cards
Function Name Port Remarks
PN-8LCAA
8
8L Analog Line Circuit
Message Waiting Control: 8 circuits
Momentary Open: 8 circuits
Loop Resistance: Max. 600ohms including
telephone set
PN-8LCS
8
8-Line Analog Station Card
Momentary Open: 8 circuits, Message
Waiting notification via Stutter Dial
Tone only. Loop Resistance: Max. 600
ohms
Note: DM & DMR must use with
PN-4LCAA.
PN-4LCD-A
4
4L Analog Line Circuit with MW Lamp
control
Momentary Open: 4 Circuits
On-Board power (80V) is included.
Loop Resistance: Max. 600ohms including
telephone set
PN-AUCA 2
2L Analog Universal Trunk
2L Long Line Circuit with PFT
Loop resistance: max. 2500ohms (LLC)
Two reverse circuits is included
On Board power (-48V) is included
PN-4LCAA 4
4-Line Analog Station Card with built-in
Ring Generator. For use with NEAX
IPS DM and DMR only, Provides Line
Test function
“No Messaging Waiting Lamp” Utilizes
Stutter Dial Tone for MW notification.
Loop Resistance: Max 600 ohms
Analog Station
PN-4LLCB 4
4L Long Line Circuit
Works in either mode:
Long Line Station
Caller ID
Loop Resistance:
Max. 2500ohms including telephone set
PZ-PW122 is required.
Can not be used in IPS
DM
or IPS
DMR
ISDN Station
SPN-2ILCA 8
2-line ISDN Line Circuit Card.
• Provides a physical interface to ISDN
Terminals.
• Occupies eight time slots per one card.