NEC NEAX 2400 ICS - Program Installation; Off-Line Startup

ND-70373 (E) CHAPTER 3
Page 19
Revision 1.0
SYSTEM STARTUP
1. Program Installation
Program installation procedure consists of the following steps.
When the system is in redundant configuration, perform system changeover by turning OFF the System 0 and repeat
the above steps.
1.1 Off-Line Startup
Off-Line Startup
HD Initialization
Basic Software Installation
Standard Service Software Installation
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
END
START
<Status change of 7 Segment LED on the EMA card>
<Startup end (off-line mode)>
• Turn Power-SW ON.
Set the SENS switch for
the system to be initial-
ized (CPU0, CPU1) to
“c” on the EMA card.