Powering On the Projector
1. Slide the lens cover.
1. Ensure that the power cord and signal cable are securely
connected. The Power indicator will turn red.
2. Turn on the projector by pressing “POWER” on the remote
control or on the control panel. The Power indicator
will ash blue. The startup screen (NEC logo) will display
and the Power indicator will turn steady blue.
4. Turn on your source (computer, notebook, video player,etc.)
The projector will detect your source automatically.
If you connect multiple sources at the same time, use the
“SOURCE” button on the control panel or use “COMP.”,
“VIDEO”, “HDMI”, “SD”, “USB-A”, “USB-B” on the remote
control to switch inputs.
Powering On/Off the Projector
Turn on the projector
rst and then the signal
sources.
or
1
2
Lens Cover
POWER
When you rst
turn on the projec-
tor, you will get the
Startup menu. This
menu gives you the op-
portunity to select the
menu languages. Select
your language. Refer to
Language on page 27.
To Next Page
Loading...
