NEC NP-NC1000C - Resetting Usage Times

63
5. Maintenance of Your Projector
4
Mount the lter cover to the projector.
1. Align the positions of the plastic clips (4 locations) with the clip receptacle holes on the
projector.
2. Push it in straight to fasten the lter cover.
Clip receptacle holes
Clip receptacle holes
This completes replacing the side air filter. If you have not yet finished replacing the rear air filter, replace the rear air
filter next (See page 58).
NOTE
Always reset the Filter2 usage time after replacing the side air filter. (See page 46)
5-3-7 Resetting the Lamp Usage Time and Air Filter Usage Time
1
Turn on the power to the projector.
2
Reset the usage time in “Conguration” → “Reset” in the adjustment menu.
•“LampUsage”:Resetsthelampusage(Seepage46)
•“FilterUsage”:Resetsthelterusage(Seepage46)
This completes resetting the lamp usage time and air filter usage time.