66
6. Appendix
6-2-3. POWER button
Indicator condition Projector condition Note
Off The projector power supply is off. -
Blinking light Orange While the projector software is starting Wait for a moment.
Green
(cycles of 1)
(Note 1)
Preparing to turn power on/cooling fan rotating
(State from turning the power off to entering standby
mode).
Wait for a moment.
Green
(cycles of 2)
(Note 2)
State where power cannot be turned off
(Immediately after turning the lamp on or immediately after
changing the lamp mode).
Wait for a moment.
(for a maximum of about 90
seconds)
Green
(cycle of 3
seconds)
(Note 3)
When the sleep timer is activated -
Steady light Green The projector is turned on. -
Orange The projector is in standby. -
(Note 1) Repeats 0.5 seconds on → 0.5 seconds off.
(Note 2) Repeats 0.5 seconds on → 1.5 seconds off.
(Note 3) Repeats 2.5 seconds on → 0.5 seconds off.
6-2-4. DOUSER button
Indicator condition Projector condition Note
Steady light Green The douser is closed. -
Off The douser is opened. -
6-2-5. LAMP ON/OFF button
Indicator condition Projector condition Note
Off The lamp is off. -
Steady light Green The lamp is on (Dual/Lamp 1/Lamp 2). -
Blinking light Green
(cycles of 2)
(Note 1)
State where the lamp cannot be turned on/off or the lamp
mode cannot be changed
(Immediately after turning the lamp on/off or immediately
after changing the lamp mode).
Wait for a moment.
(for a maximum of about 90
seconds)
(Note 1) Repeat 0.5 seconds on → 1.5 seconds off.
To Next Page
Loading...
