12
1
2
3
Replacing the Lamp
To replace the lamp, first switch off the power, wait for the cooling fans to stop and
disconnect the power plug from the outlet. Now, wait about 60 minutes before
replacing the lamp. Attempts to replace the lamp during operation or immediately
after operation has stopped will cause burns because of the high temperature.
CAUTION!
Be careful not to catch your fingers when opening or closing the projector
mounting adapter.
CAUTION!
When performing the lamp replacement work, take care not to exert force on the
projector. Application of a large force could cause the projector to fall and cause
injury.
WARNING!
Open the Projector Mounting Adapter
Remove the one screw from the front face of the projector mounting adapter.
Place your hand underneath the projector so that the mounting adapter does not
open suddenly.
Replacing the Lamp
Please refer to the instruction manual of the replacement lamp kit (Model
VT85LP/VT80LP).
Return the Projector to the Original Condition
Follow the procedure in the reverse order to fix the projector mounting adapter in
place.
NP03CME07.3.122:15PMページ12
To Next Page
Loading...
