Powering On the Projector
1. Ensure that the power cable and signal cable are securely
connected. The Power LED will ash blue.
2. Remove the lens cap.
3. Turn on the lamp by pressing “Power” on the control panel.
The startup screen (NEC logo) will display and the Power
LED will turn blue.
4. Turn on your source (computer, notebook, video player,etc.)
The projector will detect your source automatically.
If you connect multiple sources at the same time, use the
“Source” on the remote control or use “Computer”, “S-Vid-
eo”, “Video” on the remote control to switch inputs.
Powering On/Off the Projector
Turn on the projector
rst and then the signal
sources.
Lens Cap
1
Power
2
To Next Page
Loading...
