18
SELECT
SOURCE
AUTO
ADJ.
ON/STAND BY
FOCUS
LAMP
STATUS
POWER
3. Projecting an Image (Basic Operation)
➋
Selecting a Source
Selecting the computer or video source
LAMP MODE
VOLUME
S-VIDEO
VIDEO
L-CLICK
MOUSE
R-CLICK
AUTO ADJ.COMPUTER
ASPECT HELP
FREEZEPICTURE
NOTE: Turn on the computer or video source equipment connected to the pro-
jector.
Adjusting with buttons on the cabinet
1. Press the SELECT ▶ button with no menus displayed.
The Source list will be displayed.
- When the menu is displayed, press the EXIT button to close the
menu and start the operation.
2. Press the SELECT ▶ button a few times quickly to select a sig-
nal you want to display.
Each time the SELECT ▶ button is pressed, each source name will
be highlighted in sequence.
- The selected signal will be displayed.
TIP: Detecting the Signal Automatically
Press and hold the SELECT ▶ button for a minimum of 2 seconds,
the projector will search for the next available input source.
Detecting the Signal Automatically
Press and hold the SELECT ▶ button for a minimum of 2 seconds,
the projector will search for the next available input source.
Using the Remote Control
Press any one of the VIDEO, S-VIDEO and COMPUTER buttons.
To Next Page
Loading...
