NEC PA622U - ❺ Mounting the Cable Cover (Sold Separately)

267
10. Appendix
❺ Mounting the cable cover (sold separately)
Mountingtheseparatelysoldcablecover(NP04CV)ontheprojectorallowsyouhidethecablesforacleaner
appearance.
CAUTION
• Aftermountingthecablecover,besuretofastenusingthescrewsprovided.Ifnot,thecablecovercouldfall,
damagingthecablecoverandpossiblyresultingininjury.
• Donotbundlethepowercordandplaceitunderthecablecover.Doingsocouldleadtore.
• Donotapplyexcessiveforcetothecablecover.Doingsocoulddamagethe cablecover,resulting inthe
projectorfallingorcausinginjury.
Mounting
Preparations:
1. Connectthepowercordandcablestotheprojector(theconnectioncordsareomittedfromthediagrams).
2. PrepareaPhillipsscrewdriver.
1. Insert the two round protrusions on the left and right edges
of the cable cover into the grooves in the bottom of the
projector to line it up.
NOTE:Becarefulnottoletthepowercordandcablesgetpinchedbythe
cablecover.
2. Turn the cable cover screw clockwise.
• Tightenthescrewsecurely.
1
2
Removing
1. Turn the cable cover screw counterclockwise until it turns
loosely.
• Holdthecablecoverwhiledoingthistopreventitfromfall-
ing.
• Thescrewdoesnotcomecompletelyoff.
2. Remove the cable cover.
• Turnthecablecoveralittle,thenliftitoff.
1
2