NEC PA622U - Selecting Default Source

19
2. Projecting an Image (Basic Operation)
Selecting Default Source
Youcansetasourceasthedefaultsourcesothatitwillbedisplayedeachtimetheprojectoristurnedon.
1. Press the MENU button.
 Themenuwillbedisplayed.
2. Press the ▶buttontoselect[SETUP]andpressthe▼buttonortheENTERbuttontoselect[BASIC].
3. Press the ▶buttontoselect[SOURCEOPTIONS].
4. Press the ▼buttonfourtimestoselect[DEFAULTINPUTSELECT]andpresstheENTERbutton.
 The[DEFAULTINPUTSELECT]screenwillbedisplayed.
(→page128)
* ThisscreenbelongstoaHDBaseTmodel.
NOTE:
[MMModels]
• Ethernetcannotbedetectedautomaticallyevenif[DEFAULTINPUTSELECT]hasbeensetto[AUTO].Select[ETHERNET]in
[DEFAULTINPUTSELECT]toenableEthernettobeselectedautomaticallywhenpowertotheprojectoristurnedon.
5. Select a source as the default source, and press the ENTER button.
6. Press the EXIT button a few times to close the menu.
7. Restart the projector.
 Thesourceyouselectedinstep5willbeprojected.
NOTE:Evenwhen[AUTO]isturnedon,the[HDBaseT]willnotbeautomaticallyselected.Tosetyournetworkasthedefaultsource,
select[HDBaseT].
TIP:
• WhentheprojectorisinStandbymode,applyingacomputersignalfromacomputerconnectedtotheCOMPUTERINinputwill
powerontheprojectorandsimultaneouslyprojectthecomputer’simage.
 ([AUTOPOWERONSELECT]→ page 130)
• OntheWindows7keyboard,acombinationoftheWindowsandPkeysallowsyoutosetupexternaldisplayeasilyandquickly.