f)
BCR
g)
Systeni slot:
(3)
Special functions:
For connecting a
lZAlCI cartrTdge.
.
A~~tornatic power OFF
When
1.here is no program operation (awaiting
command) for ten minutes, the power is
automatically switched off.
1.2
Switches and Contrast
VR
(1)
POWER Switch
Move this switch towards the rear to turn the power ON. To conserve the
batteries, the PC-8201 automatically turns the power off if you do not use it for
10 minutes.
When an automatic power-off occurs, the switch will still be in the ON position even
though the power is OFF.
To turn the power ON. move the switch to the OFF position, then back ON.
(3)
BACK UP I'OLb'EII Switch
This switch is for preventing discharge of the
Ni-Cd battery for
RAhl
back-up.
The
I'C-8301A
will
not operate regardless of the setting of the power switch unless
this switch
is
ON. Set this switch to OFF position if the PC-8201 is not to be
used
for
a
long timc.
Nole that the RAkl will not be backed up when this switch is set to llle OFF
position.
(3)
RESET Switch
If the PC-8201
"locks-up" (the display will "freeze" and all keys seem to be
inoperative), press this button to return to the
hlain Menu (start-up) screen. It's
highly unlikely that the PC-8201
will
lock-up when you are using the built-in
Application Programs.
However, this
situation may occur with customized programs.
(4)
PROTECT Switch
This switch is for protecting the contents of 2nd
RAM.
(BANK #2)
(5)
DISPLAY ADJUSTMENT
DIAL
This control
is
for adjusting the contrast of the LCD display relative to the viewing
angle.
1-3/(1-4 blank)
To Next Page
Loading...
