NEC PE401H - Attaching the Cable Cover

10
English ...
Introduction
8 POWER ON/
OFF and LED
indicator
Power on the projector. Refer to
the “Power On/Off the Projec-
tor” section on pages 27-28.
9 ECO Dim the projector lamp which
will lower power consumption
and extend the lamp life. (refer
to page 52)
10 SOURCE Press “SOURCE” to select an
input signal.
11 AUTO ADJ. Automatically synchronize the
projector to the input source.
12 STATUS LED Indicate the projector’s tempera-
ture status.
13 LAMP LED Indicate the projector’s lamp
status.
Attaching the Cable Cover
Procedure for Attaching the Cable Cover:
1. Mount the cable cover to the projector. 
 2. Tighten two screws on both sides of the cable cover. 
Cable Cover
1
2
CAUTION:
• Be sure to tighten
the screws after
attaching the cable
cover. Failure to do
so may cause the
cable cover to come
off and fall, result-
ing in injury or
damage to the cable
cover.
• Do not put bundled
cables in the cable
cover. Failure to do
so may damage the
power cord, result-
ing a re.