⁄BSoft Dry Operation Mode
This mode dehumidifies without overcooling.
( LED lamp ON)
— 10 —
3
Set the Temperature lower than the room temperature.
4
During Dry Operation
• The indoor fan speed is automatically set to low, so the shift of the indoor fan speed is
impossible because of already being set to the best speed for Dry Operatrion by Micom
Control.
• The indoor fan may be stopped to prevent overcooling.
2
Select Soft Dry Operation.
Press the operation Mode Selection Button.
Each time the button is pressed, the operation mode is shifted in the arrow direction.
• The temperature can be set
within a range of 18°C~30°C by
1°C.
1
Press the Start/Stop Button.
Operation Display
• Two short beeps will sound and the
operation lamp will light up.
To raise the Temperature
To lower the Temperature
Beep, Beep
Cooling Operation
Soft Dry Operation
Auto Operation
Heating Operation
(Heat pump model only)
To Next Page
Loading...
