NEC SV9100 - Email Communication; Sending Group Emails

Configuration Note 4. Configuring AudioCodes E-SBC
Version 7.0 27 AudioCodes Mediant E-SBC
4.2 Step 2: Enable the SBC Application
This step describes how to enable the SBC application.
 To enable the SBC application:
1. Open the Applications Enabling page (Configuration tab > VoIP menu >
Applications Enabling > Applications Enabling).
Figure 4-4: Enabling SBC Application
2. From the 'SBC Application' drop-down list, select Enable.
3. Click Submit.
4. Reset the E-SBC with a burn to flash for this setting to take effect (see Section 4.13 on
page 62).