NEC SV9100 - Page 55

Configuration Note 4. Configuring AudioCodes E-SBC
Version 7.0 55 AudioCodes Mediant E-SBC
3. Configure another manipulation rule (Manipulation Set 4) for BroadCloud SIP Trunk.
This rule applies to messages sent to the BroadCloud SIP Trunk IP Group. This
replaces the host part of the SIP P-Asserted-Identity Header with the value from the
SIP To Header.
Parameter Value
Index
1
Manipulation Name
Change P-Asserted host
Manipulation Set ID
4
Message Type
any.request
Condition
header.p-asserted-identity exists
Action Subject
header.p-asserted-identity
Action Type
Modify
Action Value
header.to.url.host
Figure 4-32: Configuring SIP Message Manipulation Rule 1 (for BroadCloud SIP Trunk)
4. Configure another manipulation rule (Manipulation Set 4) for BroadCloud SIP Trunk.
This rule is applied to response messages sent to the BroadCloud SIP Trunk IP
Group for Rejected Calls initiated by the IP-PBX. This replaces the method type ‘502’
with the value ‘480’, because BroadCloud SIP Trunk not recognizes ‘502’ method
type.
Parameter Value
Index
2
Name
Reject Responses
Manipulation Set ID
4
Message Type
any.response
Condition
header.request-uri.methodtype=='502'