To Next Page

To Previous Page

5. Using On-Screen Menu

1 Using the Menus

NOTE:Theon-screenmenumaynotbedisplayedcorrectlywhileinterlacedmotionvideoimageisprojected.

1. Press the MENU button on the remote control or the projector cabinet to display the menu.

NOTE:ThecommandssuchasENTER,EXIT,,inthebottomshowavailablebuttonsforyouroperation.

2. Press the  buttons on the remote control or the projector cabinet to display the submenu.

3. Press the ENTER button on the remote control or the projector cabinet to highlight the top item or the ﬁrst

tab.

4. Use the  buttons on the remote control or the projector cabinet to select the item you want to adjust or

set.

 Youcanusethe buttons on the remote control or the projector cabinet to select the tab you want.

5. Press the ENTER button on the remote control or the projector cabinet to display the submenu window.

6. Adjust the level or turn the selected item on or off by using the  buttons on the remote control or

the projector cabinet.

Changesarestoreduntiladjustedagain.

7. Repeatsteps2-6toadjustanadditionalitem,orpresstheEXITbuttonontheremotecontrolortheprojec-

tor cabinet to quit the menu display.

NOTE:Whenamenuormessageisdisplayed,severallinesofinformationmaybelost,dependingonthesignalorsettings.

8. Press the MENU button to close the menu.

 Toreturntothepreviousmenu,presstheEXITbutton.

NEC UM280X User Manual

Other manuals for NEC UM280X