NEC UM330X - Correcting Keystone Distortion Manually; Adjusting with Buttons on the Cabinet

23
2. Projecting an Image (Basic Operation)
 Correcting Keystone Distortion Manually
Ifthescreenistiltedvertically,keystonedistortionbecomeslarge.Tocorrectkeystonedistortionmanually,proceed
withthefollowingstepstocorrectkeystonedistortion.
NOTE:
• TheKeystonecorrectioncancauseanimagetobeslightlyblurredbecausethecorrectionismadeelectronically.
• TheKeystonecorrectionrangecanbemadenarrower,dependingonasignaloritsaspectratioselection.
Adjusting with buttons on the cabinet
1. Press the  or  button with no menus displayed.
 Thekeystonebarwillbedisplayed.
2. Use the  or  to correct the keystone distortion.
 Thekeystonebarwillbeclosedafteraperiodoftime.
3. Press the ENTER button.
 Thekeystonebarwillbeclosed.
NOTE:
• Whenthemenuisdisplayed,theaboveoperationisnotavailable.Whenthemenuisdisplayed,presstheMENUbuttontoclose
themenuandstarttheKeystonecorrection.
 Fromthemenu,select[SETUP]→[GENERAL]→[KEYSTONE].Thechangescanbesavedwith[KEYSTONESAVE].(→page
86)
• KeystonecontrolisnotavailablewiththeorbuttonwhenVIEWERisused.