NEC Univerge SV8100 - Page 67

UNIVERGE SV8100 Issue 1.0
System Maintenance Manual 3 - 27
SECTION 11 ISDN LAYER 3 TRACE (MAIL IN 0 0 1 2) WITH SV8100 MAIN
ACTIVITY (MAIL IN 0 0 0 0)
If the same call is traced with both ISDN debug (mail in 0 0 1 2) and SV 8100 Main
Activity (mail in 0 0 0 0) switched on the trace will be as shown below.
10:12:31 >>mail in 0 0 1 2
10:12:36 >>
Enter ISDN debug mode
master current bid : 08H
master current line : 00H
mail in 0 0 0 0
10:12:40 >>Enter CAPS debug mode
== 1/JAN/2002, 10:12 ==
*(EVENT),ID:0000H,P1:0401H,P2:0013H,P3:000AH,P4:0000H,P5:0000H
>>>> PORT:0401H STATUS 0000H => 0002H
ACD Data Size error. or socket
close...*(EVENT),ID:001FH,P1:1101H,P2:0000H,P3:0000H,P4:0000H,P5:0000H
*(EVENT),ID:001FH,P1:1101H,P2:0000H,P3:0000H,P4:0000H,P5:0000H
*(EVENT),ID:001FH,P1:1101H,P2:0000H,P3:0000H,P4:0000H,P5:0000H
*(EVENT),ID:0000H,P1:0401H,P2:0008H,P3:000AH,P4:0000H,P5:0000H
*(EVENT),ID:0000H,P1:0401H,P2:0000H,P3:0001H,P4:0000H,P5:0000H
>>>> PORT:0401H STATUS 0002H => 000FH
*(EVENT),ID:0000H,P1:0401H,P2:0000H,P3:0001H,P4:0000H,P5:0000H
*(EVENT),ID:0000H,P1:0401H,P2:0008H,P3:000BH,P4:0000H,P5:0000H
*(EVENT),ID:0000H,P1:0401H,P2:000AH,P3:000AH,P4:0000H,P5:0000H
*(EVENT),ID:0000H,P1:0401H,P2:000AH,P3:000BH,P4:0000H,P5:0000H
== 1/JAN/2002, 10:12 ==
*(EVENT),ID:0000H,P1:0401H,P2:0005H,P3:000AH,P4:0000H,P5:0000H
*(EVENT),ID:0000H,P1:0401H,P2:0000H,P3:0001H,P4:0000H,P5:0000H
caps_service():Returns NORMAL
*(EVENT),ID:0000H,P1:0401H,P2:0005H,P3:000BH,P4:0000H,P5:0000H
== 1/JAN/2002, 10:12 ==
*(EVENT),ID:0000H,P1:0401H,P2:000AH,P3:000AH,P4:0000H,P5:0000H
*(EVENT),ID:0000H,P1:0401H,P2:000AH,P3:000BH,P4:0000H,P5:0000H
*(EVENT),ID:0000H,P1:0401H,P2:0002H,P3:000AH,P4:0000H,P5:0000H
*(EVENT),ID:0000H,P1:0401H,P2:0002H,P3:000BH,P4:0000H,P5:0000H
*(EVENT),ID:0000H,P1:0401H,P2:0001H,P3:000AH,P4:0000H,P5:0000H
*(EVENT),ID:0000H,P1:0401H,P2:0000H,P3:0001H,P4:0000H,P5:0000H
caps_service():Returns NORMAL
>>>> PORT:0401H STATUS 000FH => 0043H
*(INTER),ID:0401H,P1:3415H,P2:0000H,P3:083FH,P4:0000H,P5:0000H
ITR_NULL_P_STA: DES_ANSWER_FLAG CLEAR!
ITR_NULL_P_STA: TM_DES_ANSWER_WAIT_L SET!
>>>> PORT:3415H STATUS 0000H => 00D0H
*(INTER),ID:3415H,P1:0401H,P2:0000H,P3:0840H,P4:0000H,P5:0000H
>>>> PORT:0401H STATUS 0043H => 0087H
ACD Data Size error. or socket close...
*(INTER),ID:0401H,P1:3415H,P2:0000H,P3:08E5H,P4:0000H,P5:0000H
** CLR_ISDN_FLAG IS CALLED **
** LPORT_W = 3415H **
Switch on ISDN and
SV8100 Main Activity
trace
Keyphone port 1
goes off-hook
Keyphone port 1
begins dialing
8
0
5
0
2
1
To seize trunk
port 21
Keyphone port 1
uses ISDN trunk
port 21.
Trunk port 21
goes from idle to
‘reserved’.