Using the Center control allows you to adjust the spacing between the
center lines, and using the Bottom/Top control allows you to adjust the
spacing between the top and bottom lines.
Factory Preset
Selecting Factory Preset allows you to reset all OSM settings back to the
factory settings. The following warning statement will appear to confirm
that you do want to reset ALL settings. Individual settings can be reset
by highlighting the control to be reset and pressing the reset button.
WARNING
ABOUT TO RESET
ALL SETTINGS
Press:
RESET - Reset
EXIT - Cancel
Self Test
To make sure, that your monitor is working well, you can choose the
Self Test function in the following way:
Power down your monitor and your PC. Power on the monitor. While
the Exit button is held down, press the Proceed button. The following
picture is shown on the monitor. If you do not press the Exit button to
cancel the Self Test function, the monitor will show a dark screen within
20 seconds.
Self Test Menu
EXIT - Cancel
E-26 OSM Menus
To Next Page
Loading...
Need help?
General