25
Machine setting
Tape the button over the placement mark.
A pin can be placed on top of the foot to form
a shank.
Press down the drop feed lever and move it to
the right for dropping the feed dogs.
Set the zigzag width dial at “ ”. Align the both holes of the
button with the slot of the foot and place the left hole of the button
just below the needle point. Lower the foot and turn the pattern
selector until the needle point comes just above the right hole of the
button. Sew about five stitches and raise the needle. Set the zigzag
width dial at “ ” again and sew a few stitches to lock thread.
To strengthen the shank, cut the
threads leaving a 20 cm (8”) tail.
Bring the needle thread down
through the hole in the button and
wind it around the shank.
Draw the thread to the wrong side
and knot.
Sewing Buttons
To Next Page
Loading...
