4
How to set the spool pins
Spool pins are separately packed to
prevent any damage in transit.
Therefore, fix the holder of spool pins
in place with a screwdriver, as shown
in the figure.
GETTING READY TO SEW
Connecting the Machine to the Power Supply
Before connecting the power, make sure the voltage and number of cycles
of the machine conform to your electrical power.
Turn the power switch off.
Fit the nonreversible plug into the machine socket and plug the
machine into the power supply.
Turn the power switch on.
Operting instructions:
The symbol “O” of a switch indicates the “off” position of the switch.
To reduce the risk of electrical shock, this plug is intended to fit in a
polalized outlet only one way.
If it does not fit fully in the outlet, reverse the plug. If it does not fit, contact
a qualified electritian to install the proper outlet. Do not modify the plug in
any way.
The foot controller Model YC-482J-EC or TJC-150 is used with this sewing
machines.
To Next Page
Loading...
