Nedap SmartFlow - 6 Maintenance; Maintenance Scheme

Nedap SmartFlow / Installation manual
Version 00.001 / September 2020 / EN
30
Dairy Farming
6 Maintenance
Caution
• Always turn off the mains power supply when working on the electrical installation.
• Always turn off the air pressure supply when working on the pneumatic installation (if applicable).
• Never power wash the electrical components of the installation.
• Do not use corrosive and/or toxic cleaning agents.
• Any damage and/or accelerated wear due to non-compliance or complete lack of maintenance is not
covered by the manufacturer's warranty.
• Any damage caused by power washing or any other form of high pressure washing is not covered by the
manufacturer's warranty.
6.1 Maintenance scheme
Regularly clean the SmartFlow following the instructions described in Cleaning (page 28).