Nederman Customer Service & Technical Support techsupport.us@nederman.com +1 (336) 821-0800
11
Section 6.0 Installation
6.4 Off-loading & Set-up:
Step 1
When removing the unit from the skid, locate the decals (as seen below) indicating where to
insert/place the forklift forks (requires a 65” (1.65 m) min length fork) which will provide even
weight distribution and the unit tipping over while moving. Note: Unit must be placed on a level
foundation.
Step 2 – Set-up (raising the bag house roof)
Once the unit is in the desired location, raising the bag house roof requires one person at each of the four
legs/corner. (see photo below).
1) Unbolt the bag house roof legs from dust collector legs saving the nuts and bolts for step 3.
2) While holding the roof legs close to the filter legs, evenly extend/raise the bag house roof
and roof legs at the same time.
3) Once completely raised, secure the bag house roofs legs in place reusing the nuts and bolts.
Bags have a sewn in snap ring securing bag to the inside of hopper holes.
Leg bracing can be removed from one
side after the filter has been set in
place If you are using barrels.
To Next Page
Loading...
Need help?
General
