Nederman E-PAK 150 DX

Questions and Answers

S
Sabrina HansonAug 2, 2025
Why is there low vacuum or air flow in my Nederman Dust Collector?
- K
  Kenneth WilliamsAug 3, 2025
  Low vacuum or air flow can occur in your Nederman Dust Collector due to several reasons: * Deposits or blockages in the ducts leading to the unit. Clean the ducts and check the transport velocity. * The duct system may not be properly dimensioned. Re-dimension the duct system or add an extra suction source. * Valves in the duct system may not be working correctly. Check the duct system valves. * The filter cleaning might not be working or is insufficient. Check the function of the filter cleaning.
Y
ykelleyAug 8, 2025
What to do if filter cleaning doesn't work on Nederman E-PAK 150 DX?
- J
  Justin ClementsAug 8, 2025
  If the filter cleaning is not working on your Nederman Dust Collector, consider the following possible causes: * The compressed air pressure or flow might be too low. Adjust the pressure and check the hose dimension. * The solenoid valve might not be connected properly. Check the valve and air pressure. * The air lines, valve, or cylinder could be blocked. Clean or replace these components and filter incoming compressed air. * The cylinder or valve may not be functioning correctly. Replace the cylinder or valve. * The cleaning interval may be too short, extend the cleaning interval.
C
Christina EricksonAug 15, 2025
What to do if the control filter pressure switch is triggered in Nederman E-PAK 150 DX Dust Collector?
- E
  esimonAug 15, 2025
  If the control filter pressure switch is triggered in your Nederman Dust Collector, it could be due to: * A blocked control filter. Turn off the fan and verify that the yellow fault indicator light goes out. If not, the pressure sensor may be broken or the air lines blocked. Replace the control filter and check the main filter for damage. * Blocked or damaged Ø 6 mm hoses to the pressure switch. Clean or replace the hoses. * Improper connection of the pressure switch or filter. Check the connections. * A pressure switch setting that is too low. Increase the setting (default: 4 kPa (0.58 PSI)). * A broken pressure switch. Replace the switch.
J
John RamosAug 20, 2025
What to do if the explosion relief panel sensor was triggered on Nederman Dust Collector?
- J
  joseph46Aug 20, 2025
  If the explosion relief panel sensor was triggered on your Nederman Dust Collector, consider these possibilities: * The explosion relief panel may have opened due to a dust explosion in the filter. Follow dust explosion and fire procedures. * The sensor may not be positioned correctly. Test and position it correctly. * The sensor may not be connected properly. Check the connections. * The sensor may be broken. Replace it.
R
reynoldspaulAug 27, 2025
Why Nederman E-PAK 150 DX Dust Collector unit starts without any valve being opened?
- K
  Kaylee MillerAug 27, 2025
  If your Nederman Dust Collector unit starts without any valve at any workstation being opened, it is likely that the PS cable is short-circuited. Disconnect the cable from the starter and use an ohmmeter across the leads in turn to locate the fault.