To Next PageTo Next PageWhy is my Nederman Vacuum Cleaner motor not starting?
The motor may not start due to several reasons: * The electrical supply might not be connected; ensure it is properly connected. * The motor protection might be activated; refer to the section on "Motor protection activated". * There may be a defect with the power switch or cable, or the radio noise suppression card. In this case, contact the distributor.
Why does my Nederman Vacuum Cleaner have none or bad suction capacity?
The suction capacity might be reduced due to: * The switch not being completely turned on; ensure it is fully on. * A clogged suction hose or inlet; disconnect the hose and try sucking in the opposite direction, or use a rod to unclog it. * A leaking suction hose; replace the suction hose. * Leaking gaskets; remove and replace the damaged neoprene gaskets using a suitable two-component glue. * The discharge valve being open; close the valve.
What to do if motor protection activated in Nederman Vacuum Cleaner?
If the motor protection is activated: * Reset the motor protection. See Section 5.2 Reset motor protection. * Ensure adequate airflow to prevent overheating by checking for blockages in hoses, the fan's inlet, and outlet. * Verify the motor's rotation direction; it should match the arrow on the fan housing. If incorrect for three-phase operation, switch phases L1 and L3.
Why is there dust in the exhaust air of my Nederman Vacuum Cleaner?
Dust in the exhaust air may be caused by a missing, defective, or wrongly installed filter. Inspect the filter and replace it if necessary.
How to fix abnormal noise level in Nederman Vacuum Cleaner?
An abnormal noise level may arise from: * Leaking gaskets; replace any damaged neoprene gaskets using a suitable two-component glue. * A defect in the sound-absorbing material; dismantle the silencer hood, remove any dirt, and replace damaged silencing material if needed.
What to do if ball bearing temperature sensor activated in Nederman Vacuum Cleaner?
If the ball bearing temperature sensor is activated because the ball bearing temperature is too high, listen for abnormal noise from the fan. If there is abnormal noise, contact the nearest authorized distributor or Nederman service for technical advice.
General| Brand | Nederman |
|---|---|
| Model | S Series |
| Category | Dust Collector |
| Language | English |
