English | 35
Neff C77V60N01 | 09/2008
Water filter: Each time a new water filter
is inserted in the water tank (8), it must be
rinsed:
Place the water filter in the water tank
(8) and fill the tank with water up to the
“max” mark.
Use the navigation button to select
START and press (6).
Place a container with a capacity of 0.5
litres under the milk frother (19).
Press (6). Water will now run first
through the filter to rinse it and then into
the container.
Empty the container. The appliance is ready
to use once more.
The filter is no longer effective when the
Change filter display appears, or at the
latest after two months. It needs to be
replaced for reasons of hygiene and so that
there is no build-up of limescale (this could
damage the appliance). Replacement filters
can be obtained from retailers or customer
service (see “Accessories”).
After every filter change the filter must first
be rinsed. Proceed as described at the
beginning of this section.
If no new filter is used, turn the water filter
setting to Off.
If the appliance has not been used
for a prolonged period (e.g. during
your vacation) the filter should
be rinsed before the appliance
is used again. To do this, simply
dispense a cup of hot water.
1.
2.
3.
4.
Further entries in the Settings menu:
Service - descale: If you want to descale
the appliance, press (6) and run the
descaling programme (see “Descaling”).
Service - clean: If you want to clean the
appliance, press (6) and run the clean-
ing programme (see “Cleaning”).
Service - Calc‘n‘Clean: If you want to de-
scale and clean the appliance at the same
time, press (6) and run the Calc‘n‘Clean
programme (see “Calc‘n‘Clean“).
Factory settings: You can cancel your own
settings and reset the factory settings. To
activate the factory settings, press (6).
The appliance can also be reset
to the factory settings as follows:
1.Switch the appliance off fully at the
power switch O/I (7).
2.Press (2) and (5) at the same
time, hold them down, and switch the
appliance on again at the power switch
O/I (7).
The factory settings are reactivated.
Adjusting the grinding unit
The rotary selector (11) on the top of the
appliance adjusts the degree of grinding
from coarse to fine as required.
To Next Page
Loading...
