PowerBoost function en
15
Changing or deleting the time
Select a hotplate. Touch the
0 symbol and use the
@ or A symbols to change the cooking time, or set the
time to ‹‹.
When the time has elapsed
The hotplate switches off. An audible signal sounds. ‹‹
lights up in the timer display for 60 seconds.
Touch the 0 symbol. The displays go out and the
audible signal ceases.
Notes
■ If a cooking time was programmed for several
hotplates, the time information for the selected
hotplate is shown in the timer display.
■ You can set a cooking time of up to 99 minutes.
The kitchen timer
You can use the kitchen timer to set a time of up to 99
minutes.
This functions independently from the hotplates and
from other settings. This function does not automatically
switch off a hotplate.
Setting procedure
1. Touch the 0 symbol repeatedly until the V
indicator lights up. ‹‹ lights up on the timer display.
2. Touch the @ or A symbol. The basic setting appears.
@ symbol: 10 minutes.
A symbol: 5 minutes.
3. Use the @ or A symbol to set the required time.
After a few seconds, the time begins to count down.
Changing or cancelling the cooking time
Touch the 0 symbol repeatedly until the V indicator
lights up. Change or set the time to ‹‹ using the @ or
A symbol.
When the time has elapsed
An audible signal sounds. ‹‹ appears in the timer
display. The displays go out after 60 seconds.
By pressing the 0 symbol, the displays go out and the
audible signal ceases.
vPowerBoost function
Po we r Bo o s t function
The PowerBoost function enables you to heat up large
quantities of water faster than when using heat setting
Š.
This function can always be activated for a hotplate,
provided the other hotplate in the same group is not in
use (see illustration). Otherwise,
˜ and Š will flash in
the display for the selected hotplate; the
Š heat setting
will then be set automatically without activating the
function.
Note: In the combi zone, the PowerBoost function can
only be activated if the two hotplates are used
independently of each other.
Activation
1. Select a hotplate.
2. Touch the ˜ symbol.
˜ lights up on the display.
The function is activated.
Deactivation
1. Select a hotplate.
2. Touch the ˜ symbol.
The ˜ display goes out and the hotplate switches
back to the Š heat setting.
The function is deactivated.
Note: In certain circumstances, the PowerBoost
function can switch itself off automatically in order to
protect the electronic elements inside the hob.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
