EasyManuals Logo

NEFF T48FD23X2 User Manual

NEFF T48FD23X2
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
en Energy consumption indicator
20
[Energy consumption
indicator
En e r g y consumpt i on indicator
This function indicates the total amount of energy
consumed by this hob the last time it was used for
cooking.
Once the hob is switched off, the energy consumption
is displayed in kilowatt hours (e.g. .‹‰ kWh) for 10
seconds.
The accuracy of the information displayed depends on
the voltage quality of the mains power supply, among
other factors.
You can find out how to switch this function on in the
section on ~ "Basic settings"
tCookware check
Co o k wa r e check
This function can be used to check the speed and
quality of the cooking process depending on the
cookware.
The result is a reference value and depends on the
properties of the cookware and the hotplate being used.
1. Place a cold saucepan containing approx. 200 ml of
water in the centre of the hotplate the diameter of
which matches the base of the pan most closely.
2. Go to the basic settings and select the ™‚ ƒ setting.
3. Touch the @ or A symbol. A will flash on the hotplate
display.
The function has now been enabled.
After 20 seconds, the quality and speed of the cooking
process will appear in the hotplate display.
Check the result using the following table:
To activate the function again, select the @ or A symbol.
Notes
If the diameter of the hotplate used is much smaller
than the diameter of the cookware, only the middle
of the cookware can be expected to heat up. This
may result in the cooking results not being as good
as expected or being less than satisfactory.
You can find information on this function in the
section on ~ "Basic settings".
You can find information on the type, size and
positioning of the cookware in the section on
~ "Induction cooking".
Result
The cookware is not suitable for the hotplate and will therefore
not heat up.*
The cookware is taking longer to heat up than expected and the
cooking process is not going as well as it should.*
ƒ
The cookware is heating up correctly and the cooking process
is going well.
* If there is a smaller hotplate available, test the cookware again on the
smaller hotplate.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NEFF T48FD23X2 and is the answer not in the manual?

NEFF T48FD23X2 Specifications

General IconGeneral
Hob typeZone induction hob
Combi zoneYes
Product colorBlack
Hob width size80 cm
Top surface typeGlass-ceramic
Appliance placementBuilt-in
Cooking zone 1 typeSimmer
Cooking zone 2 typeRegular
Cooking zone 3 typeExtra large
Cooking zone 5 typeLarge
Cooking zone 1 power1400 W
Cooking zone 2 boost3100 W
Cooking zone 2 power1800 W
Cooking zone 2 shapeRound
Cooking zone 3 boost3700 W
Cooking zone 3 power2200 W
Cooking zone 1 positionLeft rear
Cooking zone 2 positionLeft front
Cooking zone 3 diameter240 mm
Cooking zone 3 positionCentral
Cooking zone 4 positionRight rear
Cooking zone 5 diameter210 mm
Cooking zone 5 positionRight front
Number of cooking zones5 zone(s)
Simmer cooking zone shapeRectangular
Cooking zone 2 power sourceElectric
Large cooking zone diameter190 mm
Number of gas cooking zones0 zone(s)
Simmer cooking zone diameter145 mm
Regular cooking zone diameter180 mm
Number of flexible cooking zones1 zone(s)
Timer typeDigital
Control typeTouch
Control positionTop front
Number of boosters5
Number of power levels17
AC input frequency50 - 60 Hz
Connected load (gas)- W
Connected load (electric)7400 W
Weight and Dimensions IconWeight and Dimensions
Depth522 mm
Width802 mm
Weight15203 g
Cord length1.1 m
Installation compartment depth490 mm
Installation compartment width750 mm
Installation compartment height51 mm

Related product manuals