en Basic settings
16
QBasic settings
Ba s i c s et t i ngs
There are various settings available to you in order to
help use your appliance effectively and simply. You can
change these settings as required.
List of basic settings
Depending on the features of your appliance, not all
basic settings will be available.
--------
Changing the basic settings
The function selector must be set to the "Off" position.
1. Press and hold the v button for approx.
four seconds.
The first basic setting appears in the display,
e.g. ™‚ ‚.
2. Use the ( or ) button to change the setting if
necessary.
3. Confirm by pressing the v button.
The next basic setting appears in the display.
4. Use the v button to continue going through all of
the basic settings as described above and to
change the settings if necessary using the ( or
) button.
5. To confirm, press and hold the v button again for
approx. four seconds.
All basic settings have now been applied.
You can change the basic settings again at any time.
Note: Following a power failure, the basic factory
settings are restored.
Basic setting Options
™‹ Automatic childproof
lock
‹ = no*
‚ = yes (only possible if ™‡ ‚ is set)
™‚ Display time of day? ‹ = hide the time
‚ = display the time*
™ƒ Audible signal duration
upon completion of a
cooking time or timer
duration
‚ = Approx. 10 seconds
ƒ = Approx. 30 seconds*
„ = Approx. 2 minutes
™„ Button tone that sounds
when a button is
touched
‹ = off
‚ = on*
™… Cooling fan run-on time ‚ = Short
ƒ = Medium
„ = Long*
… = Extra long
™† Amount of time until a
setting is applied
‚ = Approx. 3 seconds*
ƒ = Approx. 6 seconds
„ = Approx. 10 seconds
™‡ Enable childproof lock
activation?
‹ = no
‚ = yes*
™ˆ Water hardness** ‹ = softened
‚ = soft (up to 1.3 mmol/l)
ƒ = medium (1.3 - 2.5 mmol/l)
„ = hard (2.5 - 3.8 mmol/l)
… = very hard* (above 3.8 mmol/l)
* Factory setting (factory settings may vary depending on the appli-
ance model)
** Not available for all appliance types.
To Next Page
Loading...
Need help?
General