14 Nektar Impact LX49, LX61 & LX88 User Guide www.nektartech.com
Wheels and Foot Switch
Pitch bend and Modulation Wheels
The two wheels below the Octave and Transpose buttons are typically used for Pitch bend and Modulation.
The Pitch bend wheel is spring loaded and automatically reverts to it’s center position upon release. It’s ideal to bend notes
when you are playing phrases that require this kind of articulation. The bend range is determined by the receiving instrument.
The Modulation wheel can be freely positioned and is programmed to control modulation by default.
Both the Pitch bend and the Modulation wheel are MIDI assignable with settings stored over power cycling so you don’t lose
them when you switch the unit off. Pitch bend and Modulation assignments are not part of the Impact LX presets.
Foot Switch
You can connect a foot switch pedal (optional, not included) to the 1/4” jack socket on the back of the Impact LX keyboard.
The correct polarity is automatically detected on boot-up, so if you plug in your foot switch after boot-up is complete, you
may experience the foot switch working in reverse. To correct that, do the following
Switch the Impact LX off
Make sure your foot switch is connected
Switch the Impact LX on
The polarity of the foot switch should now be automatically detected.
Switching Wheels and Foot Switch On/Off for Layer & Split (LX88 only)
Pitch bend, modulation wheel and foot switch can each be on and off for the layer, split and the regular keyboard zones.
Read the section about Setup on page 20, for further information about how to do that.
To Next Page
Loading...
Need help?
General
