www.nektartech.com Nektar Panorama T4 & T6 User Guide 9
MIDI Out
The MIDI out connector can be used to:
• Send MIDI data externally to MIDI receiving devices directly from the keyboard and its controls.
• As a USB MIDI Out interface where MIDI data is sent from your DAW or MIDI software to the MIDI Out.
To change the behavior of the MIDI Out, go to the Global menu and change the setting as described on page 10.
Foot Switch Socket
You can connect a foot switch pedal (optional, not included) to the 1/4” jack socket on the back of the Panorama T4/T6 keyboard. The cor-
rect polarity is automatically detected on boot-up, so if you plug in your foot switch after boot-up is complete, you may experience the foot
switch working in reverse. To correct that, do the following:
• Switch the Panorama T4/T6 off.
• Make sure your foot switch is connected.
• Switch the Panorama T4/T6 on.
The polarity of the foot switch should now be automatically detected.
Expression Pedal Socket
Panorama T4/T6 works with any standard expression pedal featuring a 1/4” TRS jack such as Roland EV5, M-audio EXP and of course our
own NX-P pedal.
Connect the pedal to the socket on the rear of Panorama T4/T6. By default, the socket transmits MIDI cc 11 (expression), but you can
change the assignment in the Control Edit menu as described on page 21.
Assignments are stored and retained over power cycling .
Rear Panel Connectors
To Next Page
Loading...
Need help?
General
