Nelsen Corporation AIO Plus Connected Series User Manual

11
AIO Plus Default Cycle Step Times Minutes
Step 1 Air Release (non-adjustable) 6
Step 2 Backwash 10
Step 3 Rest 5
Step 4 Air Replenish 20
Step 5 Rapid Rinse 5
Starting Extra Regeneration Cycle
1. To Start Delayed Extra Cycle: Example: [1]
- If Days Remaining Until Next Regeneration does not read ‘1’, press and hold the Set/Change button for 3
seconds until the display reads ‘1
- Regeneration cycle will initiate at the next designated regeneration time.
2. To start Immediate Extra Cycle: First complete above step.
- Press and hold the Set/Change button.
- After 3 seconds, the regeneration cycle will begin.
3. To Fast Cycle through regeneration: First complete above 2 steps.
Press and hold the Set/Change button for 3 seconds to advance to the next cycle step.
NOTE: Fast Cycle is not necessary unless desired to manually step through each cycle step.
(Repeat until valve returns to the home display)
Regeneration Cycle
NOTE: Depending upon system pressure and other factors, it is possible to observe flow to drain in the rest cycle.
-When the valve is between positions, the display will flash the number of the step it is moving towards.
-The default time at which regeneration will occur is 12:00 a.m.
The motor’s run direction during a particular regeneration cycle step is indicated by the rotation direction of the
last 2 digit displays.
Example: 5-
AIO Plus Connected Series Programming the Control Valve

Nelsen Corporation AIO Plus Connected Series Specifications

General

Brand	Nelsen Corporation
Model	AIO Plus Connected Series
Category	Control Unit
Language	English