EasyManua.ls Logo

Nelson ez pro - Troubleshooting and Service; Common Symptoms and Solutions

Nelson ez pro
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TROUBLESHOOTING/SERVICE
SYMPTOM POSSIBLE CAUSE SOLUTION
No output to zone, pump, master • AC disconnected • check AC source, if AC is not detected
valve or no AC indicator lit by the controller, the no AC indicator
will be lit
no AC and blank display • no battery or dead battery • replace battery and press reset
LCD is blank • no AC and no battery • install battery to regain use of display,
check AC to ensure output to field
• ribbon cable is disconnected • ensure ribbon cable between the front
panel and controller board is
connected at both ends
“M-X” appears on the LCD when • MODE dial is in program position • position the MODE dial in the AUTO
trying to run a zone manually position to run a zone manually
“C-X” appears on the LCD when MODE dial is in program position • position the MODE dial in the AUTO
trying to CYCLE a program position to cycle a program
“S-X” appears on the LCD when • MODE dial is in program position • position the MODE dial at the AUTO
trying to run a 3 MINUTE TEST position to run the 3 Minute Test
procedure
The controller won’t run a • No programs on A, B, or C • enter a program with run times for the
3 MINUTE TEST zones you need. The 3 MINUTE TEST
only runs those zones with programmed
run times on them
P with a zone number appears • Wires not connected or short in • Check field wiring, check solenoid,
on LCD wires or solenoid replace solenoid
• More than 2 solenoids connected to a zone
ALL 24HR flashing on LCD • Greater than 24 hours of run time • Check zone run times and WATER
programmed BUDGET percentage
Controller is not watering and RAIN RAIN DELAY is programmed into EZ PRO • Turn large dial to RAIN DELAY position
DELAY arrow appears on LCD and Mode dial to Program, check
number of days on LCD.
Adjust as desired
RADIO CONNECT symbol appears • Controller is radio connected to an EZ • Turning any dial will disconnect
on LCD Command Programmer
Rain Sensor symbol on • Rain sensor is activated or if no rain • Check to see if jumper is installed if
sensor installed, the jumper is missing there is no rain sensor
24

Related product manuals