1 Introduction Page 13
Stud welding units Operating manual Date: July 2021
INTRA 2100/1400 07.2021 / EN Rev.: A
1.7 Declaration of Conformity
EU Declaration of Conformity in accordance with Machinery Directive
2006/42/EU Appendix II 1A
Authorized to compile technical
documentation:
STANLEY Engineered Fastening
Control and power unit for stud arc welding
The manufacturer hereby declares that the products stipulated above comply with all
relevant provisions and requirements of the following applicable directives:
2006/42/EU – Machine directive
2014/30/EU ‒ EMC Directive
The conformity assessment was conducted for machines not subject to Appendix IV with
internal production controls for manufacturing machines according to Appendix VIII.
References of the directives as published in the Official Journal of the European Union.
The following harmonized standards were used:
DIN EN IEC 60974-1:2018-12
Arc welding equipment - Part 1: Welding power sources
DIN EN IEC 60974-12:2012-03
Arc welding equipment - Part 12: Coupling devices for
welding cables
Safety of machinery - Electrical equipment of machines
- Part 1: General requirements
Degrees of protection provided by enclosures
Emil-Figge-Straße 76, 44227 Dortmund
EU type examination certificate:
Represented by the chief executive officer:
Legally binding signature:
This declaration certifies conformity with the above-mentioned guidelines
To Next Page
Loading...
Need help?
General
