QUICK INSTALLATION GUIDE FOR IS-350 & IS-420/430
Establish your telephone system type (analogue or digital) and
your Prefix requirements if needed (i.e. is a ‘9’ required to pick
up an outside line from the phone line that will be used for the
machine). For details about your telephone system, please
contact your IT department before moving on to Step 2.
1.
Note: This machine will only work on an analogue line
2.
Check that the following items are present:
Optional items:
IS-350 IS-420/430
Power Cable
Ink Cartridge
Meter (PSD)
Telephone Cable
Modem
OR
Weigh Platform
NOT IS-350
Autofeed
IS-430 ONLY
Feed Table
OR
3.
Install Meter (PSD)
Transit tape is
applied to the
Lower Conveyor
Table (all machines) and
the integrated Weigh
Platform (IS-350). This
must be removed before
the machine is used.
Catch Tray
IS-420/430 Only
22/08/2008 - 4142175Q
WARNING !
Do not connect the power to the
machine until step 7
Remove the meter (PSD) from the cardboard box.
Note the Meter Die Number before installing.
It is printed on the Meter (N3######).
Open the top cover of the machine. Fit the meter as shown in
the diagram below. On the IS-350 a cover has to be opened
first to install the meter. The meter is placed into the cavity
and then pushed forward to connect as shown in the diagram
below.
IS-350
IS-350
IS-420/30
IS-420/30
To Next Page
Need help?
General
