2
Version 2.2 Released Document February 2014
In the interest of Meter security whilst in transit, the new Meter will need to be
activated.
A registration PIN code is required to carry out this process. The PIN code can only be
obtained from the Neopost website at:
www.neopost.co.uk/pin-activation
Before visiting the website you will require the following information to obtain the
registration code:
Installation Account (found on your welcome letter)
Installation Postcode
Licence Number (Meter Die No. NExxxxxxx as shown below)
Go to the Neopost customer support website at:
www.neopost.co.uk/pin-activation
At the top centre of the page click on: IS-Pin Generator
Enter the information in the relevant fields
and press; Get Pin
A registration PIN code will be displayed. Please
make a note of this code in the box below to use
during the swap process.
Please read the following information carefully to complete the
installation of your new Meter.
Remove the Meter from the white box.
Write down the Meter Die Number as
shown in the diagram to the left in the
box below.
Next Page
NE
NE_ _ _ _ _ _ _
To Next Page
Loading...
Need help?
General
