52
10.5 Insert specifications
Remarks:
• The specification of the paper handling equipment is often wider than that of the
envelopes and documents handled. The condition of material handled will limit the
specified environmental conditions.
• We recommend that materials to be handled are stored at a temperature of 20°C (68°F)
with a relative humidity factor of 50%. If difference in temperature occurs between
store room and mailing area, the material has to be stored near the machine at least 24
hours before use.
• Self-copying paper may cause rubber parts to wear quicker. The rubber used in this
machine has the best resistance to Wiggins Teape material.
A B C D E F G
Minimum size mm 160 90 32 10 130 84
60 g/
m
2
inches 6.3 3.5 1.25 0.4 5.1 3.3
60 g/
m
2
Maximum size* mm 248 162 B-32 35 A-12** B-6 2.5***
inches 9.7 6.38 B-1.25 1.4 A-0.47** B-0.2 0.1
* Maximum insert specifications are based on single sheets. When multiples are handled,
more room inside the envelope is needed depending on the application.
** When insert is more than 1 mm (0.04 inch): A-15 mm / A-0.6 inch
*** Booklets up to approximately 1 mm (0.04 inch) thickness, depending on stiffness
To Next Page
Loading...