8
NETAFLEX™ 3G INSTALLATION MANUAL
DESCRIPTION
Specifications
Output flow rate and pressure
The NetaFlex™ 3G ensures a satisfactory mixture in a vast range of system performances.
Flow rate from 3 m
3
/h (13 GPM) to 64 m
3
/h (282 GPM) at a wide range of output pressure according to
the selected system pump.
A single NetaFlex™ 3G will accommodate from a 0.1 Ha (0.25 Acres) to a 10 Ha (25 Acres) nursery.
For output pressure lower than 3.0 bar (44 PSI) consult your local Netafim™ representative.
Fertilizer dosing capacity
The NetaFlex™ 3G accommodates up to 6 dosing channels of various types in many mixed configuration:
• 50 l/hr (13 GPH)
• 150 l/hr (40 GPH)
• 400 l/hr (105 GPH)
• 600 l/hr (158 GPH)
* For applications requiring more than 6 dosing channels - consult your local Netafim™ representative.
Basic functions
The NetaFlex™ 3G supports the following Nutrigation™ functions:
• Fully controlled dosing and mixing of fertilizers/acid with source water into a homogenous nutrient
solution.
• EC and pH correction of the nutrient solution (single or dual EC and pH control available).
Operating principle
Fertilizers and acid are injected into a tank, opened to the atmosphere; a homogeneous solution is
prepared in the tank before it is delivered to the field.
The open mixing tank method permits accelerated assimilation of fertilizers into the water. The result is a
perfectly mixed solution.
Service
The NetaFlex™ 3G utilises a modular construction making servicing a simple and prompt process.
The dealer keeps a small quantity of interchangeable components on hand, for replacement on site within
a few minutes.
Maintenance
To prevent failures and extend the life cycle of the NetaFlex™ 3G, regular maintenance must be carried out
by the user, such as periodic rinsing of filters and calibration of the EC and pH sensors.
Regular maintenance of the NetaFlex™ 3G is a prompt, low cost process requiring no special tools or skils.
To Next Page
Loading...
