6. To run the modified test, tap START. This
activates the STOPbutton while the test is
running.
7. (Optional)Tap STOPwhile the test is
running to halt the test. You can then adjust
test settings without having to wait for a
lengthy test to finish.
8. (Optional)Repeat this procedure step to add
or edit additional tests.
Auto-Populating Device Addresses
When another app is opened from the FAB, the
default address and name shown on the Top
Details Card are the targets populated.
For example, the Router shown in the Details
screen below has multiple IPv4 and MAC
addresses (which can be viewed by tapping the
Addresses card).
Discovery App
414
To Next Page
Loading...