NOTE: By default, VNC is disabled for
CyberScope Air. See General Settings > VNC to
enable and configure VNC connections.
To connect to CyberScope Air using a VNC client:
1. Get the IP address of a connected port
(preferably a management port) by swiping
down from the Status Bar at the top of the
screen to view the notification panel.
2. Provide the Wi-Fi Test or Management Port's
IP address to your chosen VNC client applic-
ation.
3. Connect using your VNC client.
4. If needed, enter the password that is set in
the VNC settings.
Using Link-Live Remote
The Link-Live Remote feature uses end-to-end
encryption, allowing secure remote control of
your CyberScope Air.
On your CyberScope Air, go to General Settings >
Link-Live Remote to ensure the feature is
enabled.
Software Management
127
To Next Page
Loading...