Back to Title and Contents
CyberScope Air must have an active network link
on the selected port to run a Path Analysis. If
Any Port is selected, available links are used in
the order shown in the Interface dialog above.
See Test and Management Ports for explan-
ations of the different ports and how to link.
Protocol: Tap to select the Connect (TCP), Ping
(ICMP), or Echo (UDP/7) protocol for your Path
Analysis.
TCP Port: This field only appears if you have
selected the Connect (TCP) Protocol. Tap to
enter the port number over which you want to
run Path Analysis. (You may need to enter a
specific port number because routes can vary
based on the port number and/or may be
blocked by firewalls.)
Path Analysis App
600
To Next Page
Loading...