NetApp ASA C Series System Documentation

If your system has… Then…
A network connection a.
Press
y when prompted to restore the backup configuration.
b.
Set the healthy node to advanced privilege level:
set
-privilege advanced
c.
Run the restore backup command:
system node restore-
backup -node local -target-address
impaired_node_IP_address
d.
Return the node to admin level:
set -privilege admin
e.
Press
y when prompted to use the restored configuration.
f.
Press
y when prompted to reboot the node.
No network connection a.
Press
n when prompted to restore the backup configuration.
b. Reboot the system when prompted by the system.
c. Select the Update flash from backup config (sync flash) option
from the displayed menu.
If you are prompted to continue with the update, press
y.
4. Ensure that the environmental variables are set as expected:
a. Take the node to the LOADER prompt.
b.
Check the environment variable settings with the
printenv command.
c. If an environment variable is not set as expected, modify it with the
setenvenvironment_variable_name changed_value command.
d.
Save your changes using the
saveenv command.
5. The next depends on your system configuration:
◦ If your system has onboard keymanager, NSE or NVE configured, go to
Restore OKM, NSE, and NVE
as needed
◦ If your system does not have onboard keymanager, NSE or NVE configured, complete the steps in this
section.
6.
From the LOADER prompt, enter the
boot_ontap command.
If you see… Then…
The login prompt Go to the next Step.
Waiting for giveback… a. Log into the partner node.
b.
Confirm the target node is ready for giveback with the
storage
failover show
command.
7. Connect the console cable to the partner node.
1026

NetApp ASA C Series Specifications

General

Brand	NetApp
Model	ASA C Series
Category	Storage
Language	English