NetApp ASA C Series System Documentation

The target port you configure is the target port you use to communicate with the
impaired node from the healthy node during var file system restore with a network
connection. You can also use the e0M port in this command.
◦
If you are configuring manual connections:
ifconfig e0a -addr=filer_addr -mask=netmask
-gw=gateway-dns=dns_addr-domain=dns_domain
▪
filer_addr is the IP address of the storage system.
▪
netmask is the network mask of the management network that is connected to the HA partner.
▪
gateway is the gateway for the network.
▪
dns_addr is the IP address of a name server on your network.
▪
dns_domain is the Domain Name System (DNS) domain name.
If you use this optional parameter, you do not need a fully qualified domain name in the netboot
server URL. You need only the server’s host name.
Other parameters might be necessary for your interface. You can enter help ifconfig at
the firmware prompt for details.
Boot the recovery image - AFF A200
You must boot the ONTAP image from the USB drive, restore the file system, and verify
the environmental variables.
Steps
1.
From the LOADER prompt, boot the recovery image from the USB flash drive:
boot_recovery
The image is downloaded from the USB flash drive.
2. When prompted, either enter the name of the image or accept the default image displayed inside the
brackets on your screen.
3.
Restore the
var file system:
If your system has… Then…
A network connection a.
Press
y when prompted to restore the backup configuration.
b.
Set the healthy node to advanced privilege level:
set
-privilege advanced
c.
Run the restore backup command:
system node restore-
backup -node local -target-address
impaired_node_IP_address
d.
Return the node to admin level:
set -privilege admin
e.
Press
y when prompted to use the restored configuration.
f.
Press
y when prompted to reboot the node.
14

NetApp ASA C Series Specifications

General

Brand	NetApp
Model	ASA C Series
Category	Storage
Language	English